EFHW QRP Antenna



This is a hand made EFHW Antenna with a built in 49:1 Transformer. This is incredible for POTA, SOTA and other portable/field operations. Setup in any end fed configuration you like.

Please let me know if you are interested in a different configuration. With wire, without, 20m, 40m, etc. I can look at offering different configuration if there is interest.

The Winder is Printed in ASA and can handle the elements but is not intended for long term or permanent outside installation.

The winder is 2-5/8" x 5" Talk about portable!

The Ferrite Toroid is a T63-43 mix, size 16mm outside dimension. 2 of these make up the core to ensure efficiency of the antenna system. This is good for up to 30W SSB and 15W CW/Digital.

If you order with Wire, you get No 26. Poly-Stealth Antenna Wire and a clip for the end. This is high quality, barely visible wire. Wire length is longer allowing you to trim to the portion of the band you like or simply fold it back at the end.

Select "Assembled 40m Wire" for a fully assembled wire winder with 68' (long for 40m) of wire and an S clip, Ferrell and heat shrink if you want to put a loop on the end.
Select "Assembled 20m Wire" for fully assembled cut to 34', again long for you to trim as desired.
Select "Assembled No Wire" for the fully assembled toroid assembly with BNC connector.
"Kits" are NOT assembled, you get to have the fun.
Per request, "Toroid +Winder..." is just the winder and 2 torroids with no wire winding.
Select "Winder only" for just the QRP winder.

Please note the end of the wire is not terminated with a loop as shown in the photo. If selection is made with wire, a ferrule, heat shrink and clip is included to terminate the end after trimming length to desired frequency and SWR match by the user.

Assembly Instructions for the kit version can be found here: tinyurl.com/tufteln

International Shipping is not warrantied but tracking is provide through ETSY.

If you are interested in shipping to another country not listed please message me to ask.